Measurement Computing 6222 - Manual (Page 28)

Specifications are subject to change without notice.
8-4 Specifications 6222 User’s Manual
Calibration
Calibration interval ............................................................. 1 year
Contact Measurement Computing for information regarding calibration service.
Note: The above calibration information pertains to hardware calibration, not to be confused with “user” or “software”
calibration. When performing a “user” calibration via Encore (or other software) keep in mind that sample rate affects both
gain and offset of the hardware, and therefore any “user” calibration should be performed at the same sample rate that is
intended for measurements.
Accessories
TR-60U 24VDC @ 0.8A (max) universal power supply
CA-1 120V IEC AC Mains cable (US)
CA-216 220V IEC Mains Cable (EU)
CA-74-1 RJ12 Shielded Cable, 6-Conductor, Sync, 0.3m (1ft) 1
190658A-01 Stacking plate kit; includes:
2 stacking plates
8 screws (8-32x0.5in, Phillips Flat, 82 degree)
CN-271
Backshell connector kit; includes:
1 plastic backshell connector and
1 screw-terminal connector
HA-210-5-BK:
Handle kit; Includes:
1 molded black plastic handle
2 screws (1/4-20x7/8in, Phillips Pan Head)
CA-192-7C Ethernet Crossover Cable, 2.133m (7ft) 2,3
CA-242 Ethernet Patch Cable, 0.457m (1.5ft) 2
CA-242-7 Ethernet Patch Cable, 2.133m (7ft) 2
Cable Notes:
1 Up to nine units can be synchronized. The total combined length of the SYNC cables is
not to exceed 2.438m (8 ft).
2
Ethernet cable length must be <3 m (9.8 ft) in order for the system to be CE Compliant.
3 An Ethernet crossover cable must be used when connecting a 6000 Series device directly
to the host PC.