Measurement Computing USB-3101FS - Manual (Page 11)

11
Chapter 3
Functional Details
Components
The USB-3101FS has the following external components:
 Screw terminal connectors
 USB port
 LED
 Strain relief slot for USB cable
Figure 2. Front panel (Screw terminal connections)
Figure 3. Rear panel (USB connection and LED)
Screw terminals
The USB-3101FS has a ten-position detachable screw terminal block that provide connections for four analog
output channels. Signal assignments are listed in the following table.
Screw terminal pin assignments
Terminal Signal
0
AO 0
1 Common (COM)
2 AO 1
3 Common (COM)
4 AO 2
5 Common (COM)
6 AO 3
7 Common (COM)
8 NC (No connection)
9 Common (COM)
Connect the positive lead of a voltage signal to the A0 terminals. Use 12 AWG to 24 AWG wires to connect the
signals. Common terminals (COM) are internally connected to the isolated ground reference of the device.