Measurement Computing USB-2001-TC - Manual (Page 17)

USB-2001-TC User's Guide Specifications
17
Safety voltages
Connect only voltages that are within these limits.
Table 6. Safety voltage specifications
Parameter Conditions Specification
Isolation Channel-to-earth ground +30 V maximum (Note 3)
Note 3: Measurement Category I is for measurements performed on circuits not directly connected to the
electrical distribution system referred to as MAINS voltage. MAINS is a hazardous live electrical
supply system that powers equipment. This category is for measurements of voltages from specially
protected secondary circuits. Such voltage measurements include signal levels, special equipment,
limited-energy parts of equipment, circuits powered by regulated low-voltage sources, and electronics.
Bus interface
Table 7. Bus specifications
Parameter Specification
USB specification USB 2.0 Full-Speed
Device compatibility USB 1.1, USB 2.0
Mechanical
Table 8. Mechanical specifications
Parameter Specification
Dimensions 62.56 mm (L) x 38.10 mm (W) x 20.32 mm (H)
2.46 in. (L) x 1.50 in. (W) x 0.80 in. (H)
Cable Length 2 meters (6.5 feet)
Weight Approximately 116 g (4.1 oz)
Environment
Table 9. Environmental specifications
Operating temperature range 0 to 55 ° C
Storage temperature range –40 to 85 ° C
Operating humidity 10 to 90% non-condensing
Storage humidity 5 to 95% RH, noncondensing
Maximum altitude 2,000 m (at 25 ºC ambient temperature)
Pollution degree 2
Note 4: The USB-2001-TC is intended for indoor use only.