Measurement Computing USB-1608FS - Manual (Page 7)

7
Chapter 2
Installing the USB-1608FS
What comes with your USB-1608FS shipment?
The following items are shipped with the USB-1608FS.
Hardware
 USB-1608FS
 USB cable
Software
 MCC DAQ CD
Documentation
In addition to this hardware user's guide, you should also receive the Quick Start Guide. This booklet provides
an overview of the MCC DAQ software you received with the device, and includes information about installing
the software. Please read this booklet completely before installing any software or hardware.
Unpacking
As with any electronic device, take care while handling to avoid damage from static electricity. Before
removing the USB-1608FS from its packaging, ground yourself using a wrist strap or touch either the computer
chassis or other grounded object to eliminate any stored static charge.
If the device is damaged, notify Measurement Computing Corporation immediately by phone, fax, or email.
 Knowledgebase:
kb.mccdaq.com
 Phone: 508-946-5100 and follow the instructions for reaching Tech Support
 Fax: 508-946-9500 to the attention of Tech Support
 Email:
techsupport@ mccdaq.com
For international customers, contact your local distributor. Refer to the International Distributors section on our
web site at
www.mccdaq.com/International .
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the MCC DAQ CD. This booklet is
available in PDF at
www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf .
Installing the hardware
Be sure you are using the latest system software
Before installing the device, run Windows Update to update your operating system with the latest HID and USB
drivers.
To connect the USB-1608FS to your system, connect the USB cable to a USB port on your computer or to an
external USB hub that is connected to your computer.
The USB-1608FS installs as a composite device with separate devices attached. When you connect the device
for the first time, a
Found New Hardware dialog opens as each device interface is detected. This is normal.
After the device is installed its LED will blink and then remain on. This indicates that communication is
established between the USB-1608FS and your computer.