Measurement Computing USB-1208HS-4AO - Manual (Page 7)

7
Chapter 2
Installing the USB-1208HS-4AO
What comes with your shipment?
The following items are shipped with the USB-1208HS-4AO:
Hardware
 USB-1208HS-4AO
 USB cable
Software
MCC DAQ CD
Documentation
In addition to this hardware user's guide, you should also receive the Quick Start Guide. This booklet provides
an overview of the MCC DAQ software you received with the device, and includes information about installing
the software. Please read this booklet completely before installing any software or hardware.
Unpacking
As with any electronic device, take care while handling to avoid damage from static electricity. Before
removing the USB-1208HS-4AO from its packaging, ground yourself using a wrist strap or touch either the
computer chassis or other grounded object to eliminate any stored static charge. If the device is damaged, notify
Measurement Computing Corporation immediately by phone, fax, or email.
 Knowledgebase: kb.mccdaq.com
 Phone: 508-946-5100 and follow the instructions for reaching Tech Support
 Fax: 508-946-9500 to the attention of Tech Support
 Email:
[email protected]
For international customers, contact your local distributor. Refer to the International Distributors section on our
web site at
www.mccdaq.com/International .
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the MCC DAQ CD. This booklet is
available in PDF at
www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf .
Installing the hardware
Be sure you are using the latest system software
Before you install the device, run Windows Update to update your operating system with the latest USB drivers.
Install the MCC DAQ software before you install your board
The driver needed to run your board is installed with the MCC DAQ software. Therefore, you need to install the
software before you install your board. Refer to the Quick Start Guide for instructions.
To connect the USB-1208HS-4AO to your system, turn your computer on, and connect the USB cable to a USB
port on your computer or to an external USB hub connected to your computer. The USB cable provides power
and communication to the USB-1208HS-4AO.
When you connect the USB-1208HS-4AO for the first time, a Found New Hardware dialog opens when the
operating system detects the device. The Status LED turns on; this indicates that communication is established
between the device and the computer. Refer to Figure 2 on page 9 for the location of the Status LED. When the
dialog closes, the installation is complete.