Directed Electronics 1401 - Manual (Page 30)

22 © 2011 Directed Electronics. All rights reserved.
Use one of the below methods to exit Smart Start mode:
•
Perform the same steps you followed to activate Smart Start mode
• Turn the ignition On
• Press the brake pedal
The parking lights flash 5 times slowly to confirm the remote has exited Smart
Start mode.
➢
Turning on the rear defogger
The optional rear defogger may be programmed to automatically activate
when remote start is turned on. If the interior cabin temperature is above 55˚ F
the defogger will not activate.
To manually activate the rear defogger after remote start is on:
•
Press
A U X
four times, and then press
A U X
. The parking lights flash 3 times
to confirm the defogger activation.
During the next remote start activation, the defogger activation resumes
normally.
➢
Pit Stop mode
The Pit Stop mode feature allows the vehicle to remain running after the key
has been removed from the ignition. This feature is useful for occasions when
you want to exit and lock the vehicle for short periods of time, but would like
to leave the motor running and the climate controls on.
To perform Pit Stop mode:
1. Before turning Off the engine, press and release the
A U X
button on the
transmitter.
The parking lights flash one time to confirm that Pit Stop mode has been
initiated, then wait a few seconds.
2. Turn the ignition key to the Off position (The engine remains running).
3. Exit the vehicle and lock the system with the remote.
The engine runs until the pre-programmed time elapses or a shut-down
input is received.