Configuring your remote, Press, On the remote again – Directed Electronics 1401 User Manual

Page 22: Button followed by the

Press

A U

on the remote again.

➢

Configuring your remote

The remote control has a menu for programming user features. Before you start

make sure the keypad is unlocked. (See Button Auto Lock )

To configure the remote user features:
1. Press and hold the

A U

button on the remote for 8 seconds. The remote

transmit LED turns on solid to indicate the Main Menu.

2. Press and hold the

A U

button for 1.5 seconds: The remote LED blinks

two-times. You are now in the Remote Configuration menu. From this

menu you can now configure the remote's keypad lock features, as

described in the following steps.

Note: To exit Remote Configuration menu:
Press and release the

A U

button to go back and repeat to exit. The transmit LED

turns off when programming is exited.

Button Auto Lock
When On, the remote Control buttons lock if more than 20 seconds lapses

between button presses. If a button is pressed when locked, the transmit LED

does not light up to indicate that the buttons have been locked. To unlock
the buttons; press the

A U

button followed by the

A U

button. The transmit LED

flashes three times to confirm.
Button Auto Unlocking
After turning the ignition off, the remote unlocks the buttons until the next com-

mand is performed. If you do not want Auto Unlocking, it can be turned off by

an authorized Directed Dealer.

Car Select
Car 2 must first be turned On (See Remote Features menu in the following Pro-
gramming section to turn on). Press and hold the

A U

button for 3 seconds. The

remote flashes the LED once or twice to indicate the selected Car is 1 or 2,

release the button for Car Select or continue holding for programming. Release