Directed Electronics 1401 - Manual (Page 10)

2 © 2011 Directed Electronics. All rights reserved.
System maintenance
The system requires no specific maintenance. Your remote is powered by a
small coin cell lightweight 3-volt lithium battery that lasts approximately one
year under normal use. The remote uses one CR2032 cell battery. When the
battery begins to weaken, the operating range is reduced.
Low battery indicator
When the battery is low on the remote the vehicle system emits an additional
honk when unlocking to let you know it is time to change the battery.
Note: The optional horn honk should be installed for the system to emit any
additional honks during unlocking. Ask your authorized dealer if you have any
questions.
Battery replacement
1. Using a small slotted
screwdriver, insert into slot
located as shown and
carefully pry the front of
the unit open until front
is completely separated
from housing.
2. Turn both the unit front
and circuit board over,
remove battery from clip
and replace.
Note:
Verify that the bat-
tery polarity is correct
when replacing.
3. Reposition all parts
and snap together.
+
+
Detail
+
+
Detail
+
+
Detail
+
+
Detail