Measurement Computing CIO-PDISO8 - Manual (Page 9)

CIO-PDISO8 User's Guide Installing the CIO-PDISO8
8
Unpacking the board
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the CIO-PDISO8 from its packaging, ground yourself using a wrist strap or by
simply touching the computer chassis or other grounded object to eliminate any stored static charge.
If any components are missing or damaged, notify Measurement Computing Corporation immediately by
phone, fax, or e-mail:
 Phone: 508-946-5100 and follow the instructions for reaching Tech Support.
 Fax: 508-946-9500 to the attention of Tech Support
 Email:
[email protected]
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data
Acquisition Software CD. This booklet is available in PDF at
www.mccdaq.com/PDFmanuals/DAQ-Software-
Quick-Start.pdf .
Configuring the CIO-PDISO8
The CIO-PDISO8 has one base address switch, one input filter switch, and one wait state jumper which you
must set before installing the board in your computer . The InstaCal calibration and test program included with
the CIO-PDISO8 will show you how to set the switches. Run InstaCal before you open your computer and
install the board. The CIO-PDISO8 is shipped with the factory-default settings listed below.
Factory-configured default settings
Switch/jumper Default setting
Base address switches 300h (768 decimal)
Input Filter Select switches
Wait State jumper OFF position
Figure 1. Switch and jumper locations