Measurement Computing CIO-DAS08 - Manual (Page 15)

CIO-DAS08 User's Guide Installing the CIO-DAS08
19
37
1
20
37 19
20
1
The red stripe
identifies pin # 1
Figure 10. BP-37 cable
Field wiring, signal termination, and conditioning
You can use the following screw termination and signal conditioning products with the C37FF-x or C37FFS
cable.
ƒ CIO-MINI37 – 37-pin screw terminal board. Details on this product are available on our web site at
www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=102&pf_id=255 .
ƒ CIO-TERMINAL – 37-pin screw terminal board with on-board prototyping area. Details on this product are
available on our web site at www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=102&pf_id=282 .
ƒ CIO-SPADE50 — 16" x 4" termination panel which mates with both 37-pin and 50-pin connectors. Details
on this product are available on our web site at www.mccdaq.com/pdfs/screw.pdf
ƒ BP-37 – Backplate with 37-pin male connector/cable. Details on this product are available on our web site
at www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=103&pf_id=1 .
ƒ CIO-EXP16 – 16-channel analog multiplexer board with on-board CJC sensor. Details on this product are
available on our web site at www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=126&pf_id=249 .
ƒ CIO-EXP32 – 32-channel analog multiplexer board with an on-board CJC sensor and 2 gain amps. Details
are available on our web site at www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=126&pf_id=250 .
Information on signal connections
General information regarding signal connection and configuration is available in the Guide to Signal
Connections (available at
www.mccdaq.com/signals/signals.pdf ).
15