Dakota Digital MCL-2004(-R) - Manual (Page 9)

MAN# 650304:F
FUNCTION SWITCH
The function switch on the side of the dash panel allows access to all of the mileage, rpm, and performance
information. Pressing and releasing the function switch toggles through the different displays. Press and holding the
switch will reset the current display. The display sequence is as follows:
CLOCK > 12 : 00 12 hour clock
ODOMTR > 000000 odometer mileage
TRIP A >
A
000.0 trip meter mileage A
TRIP B >
B
000.0 trip meter mileage B
SERVIC > S 0000 miles since last service (if programmed)
KPH > ++++++ metric speed conversion (to mph if metric unit is selected)
* HI SPD > HI 00 high speed recall
* 0-60 T > 60 00.0 0-60mph time (0-100kph)
* QUARTR > 25 00.0 quarter mile time
* QT MPH > 25 00 quarter mile speed
RPM > 0000
RPM
rpm reading in alpha display
* HI RPM > H 0000 high rpm recall
VOLTS > 00.0
V
displays voltage to gauge
PRESSURE > 00
P
pressure reading (only shown if sender is connected)
TEMP > 000 F temperature reading, “C” if metric (only show if sender is connected)
* HOURS > HR 0.0 re-settable hour meter
RANGE > R 250.0 or range distance to empty (if turned on)
The 0-60 and ¼ mile timers are zeroed by pressing and holding the switch while that timer is displayed. The timer will not
restart until the speed reaches zero and then you start driving again.
Display functions with a ‘*’ in front of them are only shown with performance readings turned on.
WIRING COLOR CODE FOR GAUGE:
MCL-2004
Stock harness color Function
BLUE temperature sensor signal
BLACK temperature sensor ground
PURPLE WHITE high beam indicator(+)
WHITE/GREEN TAN neutral indicator(-)
GRAY pressure sender
BROWN GREEN/YELLOW oil warning indicator(-)