Digital Networks North America DNswitch 800 - Manual (Page 46)

36 Configuring and Monitoring the Switch DNswitch 800
VLAN Port Configuration
Use this screen to configure port-specific settings for IEEE 802.1Q VLAN
features.
Figure 3-29. VLAN Port Configuration
Parameter Description
PVID The VLAN ID assigned to untagged frames received on this
port. Use the PVID to assign ports to the same untagged VLAN.
Acceptable Frame
Type
1
This switch accepts “All” frame types, including VLAN tagged or
VLAN untagged frames. Note that all VLAN untagged frames
received on this port are assigned to the PVID for this port.
Ingress Filtering
1 If set to “True,” incoming frames for VLANs which do not include
this port in their member set will be discarded at the inbound
port.
GVRP Status
2 Enables or disables GVRP for this port. When disabled, any
GVRP packets received on this port will be discarded and no
GVRP registrations will be propagated from other ports.
Note that GVRP must be enabled for the switch before this port
setting can take effect. (See Configuring Bridge MIB Extensions
on page 26.)
GVRP Failed
Registrations
2
The total number of failed GVRP registrations, for any reason,
on this port.
GVRP Last PDU
Origin
2
The Source MAC Address of the last GVRP message received
on this port.
1
This control does not affect VLAN independent BPDU frames, such as GVRP
or STP. However, it does affect VLAN dependent BPDU frames, such as GMRP.
2
Note that GVRP is not implemented in the current firmware release.