DirecTV HIRD-D11 - Manual (Page 69)

PROGRAMMING YOUR REMOTE CONTROL
P AGE 8-3
VCR CODE NUMBER
159
Sansui 043 048 135 022
Sanyo 003 010 102 007 014 134
Scott 017 037 044 129 131 112
159
Sears 003 008 009 010 013 014
017 081 101
Sharp 031 054 053
Shintom 024
Signature 034
Sony 056 057 058 003 052 149
031 155
VCR CODE NUMBER
Soundesign 034
STS 013
Sylvania 031 059 034 067
Symphonic 034
Tandy 010 034
Tatung 039 043 023
Teac 034 039 043 023
Technics 031 070
Teknika 031 019 034 101
TMK 006
Toshiba 112 008 131 047 059 082
013 042
VCR CODE NUMBER
Totevision 040 101
Unitech 040
Vector
Research 012
Video Concepts 012 046 034 141
Videosonic 040
Wards 003 013 024 031 034 040
053 054 017 131
Yamaha 012 043 034 039
Zenith 072 080 056 048 034 101
058
Using the Remote Control
Once your codes are entered, you are ready to start using your universal remote control. The device
keys allow you to switch from one device to another. Some keys behave in a special way. They control
one device while you are actually in another device mode. For instance, while in SATellite mode,
pressing Volume +/- controls your TV’s volume—not a digital satellite receiver volume. This is
because the remote control knows that there is no volume control on the digital satellite receiver.
Advanced feature keys (i.e. , ) are not supported for devices other than your digital
satellite receiver. For other devices, only the primary keys (i.e. and , ) will function.
•
For Sony-brand devices, use the key as the “Enter” key.
•
For RCA-brand devices, the device key (i.e., “TV” or “VCR”) might be the “power on” key and
is the power off key.
Switching the Remote Control to Operate Additional
Digital Satellite Receiver
Your remote control can be reprogrammed to operate additional digital satellite receivers. This may be
necessary in situations where multiple digital satellite receivers are located in the same general area
and can pick up signals intended for each other.
To switch the remote control, simply press and hold the key while entering the receiver ID.
The receiver ID can be 001 through 004. Do not forget the two zeros. Remember to access the
ADVANCED PREFERENCES screen using the keys on the front of the digital satellite receiver to
pair it with the remote control.
Identifying Codes that Have Been Stored
You can determine the codes that are stored in your remote control. This may be useful for
reprogramming additional remote controls later on.
1. Press the device key and the “Mute” key simultaneously.
2. Press the key and count the number of times the red light on the top of the remote control
blinks. Each digit of the three-digit code is separated by a 3-second period the light is off. For example,
if the code number is 021, the light will blink 10 times (for “0”), pause three seconds, blink twice,
pause three seconds, and blink once.