DirecTV HIRD-D11 - Manual (Page 20)

DIRECTV SYSTEM FROM HUGHES NETWORK SYSTEMS - OWNER’S MANUAL
P AGE 4-2
Determine Where to Point Your
Satellite Dish Antenna
The INSTALLATION screen
When you press you will see a screen that assists you with the satellite dish antenna
pointing and signal strength utilities.
Move the highlight to the Position button and press . You
will need to determine your location by either ZIP code or by your
latitudinal and longitudinal position. Press the or keys on the
remote control or receiver front panel until your preferred selection
is highlighted. Then press
.
You will now see a pop-up panel with space to enter your
information. Enter your location. If you are using the remote control,
press the
key, followed by the five appropriate digits. From
the remote control or receiver front panel you can also use the or
keys to increase or decrease the highlighted digit value, and the
key to advance to the next digit. Use the key to back up to correct
any mistakes. When you are finished, highlight the OK button and
press
to continue.
ALIGNMENT RESULT Pop-up Panel
The ALIGNMENT RESULT will display the proper elevation and azimuth for pointing the
satellite dish antenna calculated from the information you entered.
Take a moment to write down the pointing results.
ELEVATION:
______
AZIMUTH:
______
The values displayed are fairly accurate; however some fine-tuning
may be necessary. Use these values when choosing a mounting
location for your satellite dish antenna and remember that you will
need an unobstructed view in that direction.
Choosing the Antenna
Installation Site
WARNING
For your own safety, follow these important safety rules:
•
Perform as many functions as possible on the ground.
•
Do not install the antenna on a rainy or windy day.
•
If you start to drop the antenna or mast assembly, get away
from it and let it fall.
The INSTALLATION screen
The ALIGNMENT RESULT screen