Mathey Dearman Band Machine - Manual (Page 26)

26
9 .0 Use Condition
9.1 Condition of use

The purpose of the Band Crawler is indicated on section 2.1. Any other use, different from what is listed in section 2.1,
could be hazardous to the operator.

The Band Crawler should be placed in a safe place protected from rain, extreme humidity, mud or accidental impact.

The Band Crawler should never be operated in an extremely humid environment such as fog or rain.

Adopt all the safety devices supplied or suggested by the manufacturer.

No modification to the Saddle Machine or its accessories should be done without the previous written approval by the
manufacturer.

Remember the Motor Control Box is attached to the power source current is applied to the motor control box. The Motor
Control Box should be disconnected from the power source when not in use.
9.2 Use of the Band Crawler not allowed by the Manufacturer
 Tampering with the electrical circuit of the Motorized Band Crawler.
 Operation of the Band Crawler without the appropriate safety devices.
 Perform maintenance with electrical current applied to the Band Crawler.
 Use of a liquid or foam fire extinguisher to extinguish a fire in or near the Band Crawler.
9.0 Disposal of the Band and Band Crawler
9.1 General Information
Do not dispose of any components recklessly without regard for the environment. Separate the components by category for a
possible reuse. All national and state regulations should be followed when disposing of waste.
9.2
Composition of the Major Components
Component Description Material
Crawler Body, Rear Ball Leg, Front Ball Leg, Rear Flange Leg Assembly Aluminum
Front Flange Leg Assembly
End Plug, Connector, Worm Shaft Assembly, Drive Wheel Assembly
Carbon Steel
Bearings, Latch Spring, Latch Anchor, Long Anchor Block
Motor Mounting Bracket
Motor Control Box Cover
Stainless Steel
Electrical Cords Rubber coated copper
Cord Retention Holder Plastic