Marantz SR9600N - Manual (Page 61)

57
ENGLISHENGLISH
Recording the video from one source and
the audio from another
You can add the sound from one source to the
video of another source to make your own video
recordings.
Below is an example of recording the sound from a
compact disc player connected to CD IN and the
video from a video camera connected to VCR1 to
video cassette recorder connected to the VCR2/
DVD-R OUT jack.
1. Switch the video input source to VCR1 by
tapping the
VCR1 on page 1/8 on the remote
control unit.
2. Switch the audio input source to CD by
tapping the
CD on page 1/8 on the remote
control unit.
3. “ CD ” is now selected as the audio input
source and “ VCR1 ” as the video input source.
Notes:
• If you change the input source during recording,
you will record the signals from the newly
selected input source.
• You cannot record surround effects.
• Digital input signals are only output to the digital
outputs. There is no conversion from digital to
analog.
When connecting CD players and other digital
components, do not connect only the digital
terminals, but the analog ones as well.
1/8 A/V Amp
Source Select
wed Jun 01 4:40 pm
1.
2.
Adjust the speaker output levels so that you
can hear the same sound level from each
speaker at the listening position. For the front
left, front right, center, surround left, surround
right and surround back speakers, the output
levels can be adjusted between –12 to +12 dB.
The subwoofer can be adjusted between –18
and +12 dB.
These adjustments result will be stored to the
7.1 CH. Input memory.
3. Adjust the main volume with the VOLUME
control knob on the front panel or the VOL /
buttons on the remote.
To cancel the 7.1 CH. Input setting, press the 7.1
CH INPUT button on the front panel or tap the 7.1
input off on the remote control unit.
Notes:
• When the 7.1 CH. Input mode is activated, you
may not select a surround mode, as the external
decoder determines processing.
• In addition, there is no signal sent to the record
outputs when the 7.1 CH. Input mode is activated.
• The SR9600 has two input modes: 5.1 channel
and 7.1 channel. Set the input mode on the 7.1 CH
INPUT SETUP menu. (See page 33)
5.1 Channel Input mode:
Surround processing such as for THX music is
performed for 5.1 channel input, excluding
surround back left and right channels.
7.1 Channel Input mode:
Surround processing is not performed for 7.1
channel analog input.
7.1 CH INPUT
The SR9600 is equipped for future expansion
through support for SACD multichannel or DVD-
Audio players.
When this is selected, the input signals connected
to the L (front left), R (front right), C (center), SL
(surround left), SR (surround right), SBL (surround
back left) and SBR (surround back right) channels
of the 7.1 CH. In jacks are output directly to the
front (left and right), center, surround (left and
right) and surround back speaker systems as well
as the pre-out jacks without passing through the
surround circuitry.
In addition, the signal input to the SW (subwoofer)
jack is output to the PRE OUT SW (subwoofer) jack.
The video input source for 7.1 channel input is set
on the 7.1 CH INPUT SETUP menu. (See page 33)
This permits simultaneous viewing with video
sources.
1. Press the 7.1 CH INPUT button on the front
panel or tap the 7.1 input on (page 1/8) on the
remote control unit to switch to 7.1 channel
input.
2. If it is necessary to adjust the output level of
each channel, tap the
CH Sel and Ch Level
(PAGE6/8) on the remote control unit.
MULTI MULTI SPEAKER SPEAKER
F/P BAND THX THX PURE DIRECT PURE DIRECT UP UP DOWN DOWN TUNING TUNING
AUX 1 INPUT R AUDIO DIGITAL S-VIDEO L VIDEO POWER ON/STANDBY
VOLUME
UP DOWN
INPUT SELECTOR
PHONES PHONES
STANDBY
RROUND RECEIVER SR9600 AV SURROUND RECEIVER SR9600
SURROUND SURROUND
MIC
ENTER ENTER MENU MENU
PURE DIRECT PURE DIRECT THX THX 7.1CH INPUT 7.1CH INPUT
MODE MODE AUTO AUTO MULTI MULTI
A/B
T-MODE T-MODE MEMORY CLEAR
DISPLAY DISPLAY
EXIT EXIT
SPEAKERS MRAC
AUTO TUNE AUTO TUNE
1.
1/8 A/V Amp
Source Select
wed Jun 01 4:40 pm
1.
6/8 A/V Amp
Tone Adjust
wed Jun 01 4:40 pm
2.
MULTI SPEAKER
F/P F/P BAND BAND THX PURE DIRECT P UP DOWN TUNING
AUX 1 INPUT AUX 1 INPUT R R AUDIO AUDIO DIGITAL DIGITAL S-VIDEO S-VIDEO L L VIDEO VIDEO POWER ON/STANDBY
VOLUME VOLUME
UP UP DOWN DOWN
INPUT SELECTOR
PHONES STANDBY
AV SURROUND RECEIVER SR9600
SURROUND
MIC MIC ENTER MENU
PURE DIRECT THX 7.1CH INPUT
MODE AUTO MULTI
A/B A/B
T-MODE T-MODE MEMORY MEMORY CLEAR CLEAR
DISPLAY DISPLAY
EXIT EXIT
SPEAKERS SPEAKERS MRAC MRAC
TO TUNE AUTO TUNE
3.
H Ex M S
VOL CH OK
3.
SPEAKER A/B
The SR9600 allows you to select speaker system A
and speaker system B for the front L/R channels.
You can select these systems by pressing the
SPEAKERS A/B button on the front panel or by
tapping Spk-A on/off and Spk-B on/off (page 7/8)
on the remote control unit.
AUX2 INPUT
If you don’t need to connect 7.1 channel input
terminals for multichannel decoding, the L (front
left) and R (front right) input terminals can be used
for AUX2 input.
In this case, you can connect additional audio
sources to AUX2.
1. To select AUX2, turn the INPUT SELECTOR
knob on the front panel.
Tap the
A/V Amp on the remote control unit
and press the page up button until page 1/8 is
displayed. Tap the AUX2 on the remote
control unit.
MULTI MULTI SPEAKER SPEAKER
F/P F/P BAND BAND THX PURE DIRECT UP UP DOWN DOWN TUNING TUNING
AUX 1 INPUT AUX 1 INPUT R AUDIO DIGITAL DIGITAL S-VIDEO S-VIDEO L VIDEO VIDEO POWER ON/STANDBY
VOLUME VOLUME
UP DOWN DOWN
INPUT SELECTOR
PHONES
STANDBY
AV SURROUND RECEIVER SR9600
SURROUND
MIC MIC
ENTER ENTER MENU MENU PURE DIRECT THX
7.1CH INPUT 7.1CH INPUT
MODE AUTO MULTI MULTI
A/B A/B
T-MODE T-MODE MEMORY MEMORY CLEAR CLEAR
DISPLAY DISPLAY
EXIT EXIT
SPEAKERS SPEAKERS MRAC MRAC
AUTO TUNE AUTO TUNE
7/8 A/V Amp
Speaker A/B
wed Jun 01 4:40 pm
1/8 A/V Amp
Source Select
wed Jun 01 4:40 pm
1.
MULTI SPEAKER
F/P BAND T THX PURE DIRECT PURE DIRECT UP DOWN TUNING
AUX 1 INPUT R AUDIO DIGITAL S-VIDEO L VIDEO POWER ON/OFF POWER ON/OFF
VOLUME
UP DOWN
INPUT SELECTOR INPUT SELECTOR
PHONES PHONES STANDBY STANDBY
AV SURROUND RECEIVER SR9600 AV SURROUND RECEIVER SR9600
SURROUND SURROUND
MIC
ENTER MENU
PURE DIRECT PURE DIRECT THX 7.1CH INPUT
MODE MODE AUTO MULTI
A/B
T-MODE MEMORY CLEAR
DISPLAY
EXIT
SPEAKERS MRAC
AUTO TUNE
1.
MULTI SPEAKER
F/P BAND THX THX PURE DIRECT PURE DIRECT UP DOWN TUNING
AUX 1 INPUT R AUDIO DIGITAL S-VIDEO L VIDEO POWER ON/OFF POWER ON/OFF
VOLUME
UP DOWN
INPUT SELECTOR INPUT SELECTOR
PHONES PHONES STANDBY STANDBY
AV SURROUND RECEIVER SR9600 AV SURROUND RECEIVER SR9600
SURROUND SURROUND
MIC
ENTER MENU
PURE DIRECT PURE DIRECT THX THX 7. 7.1CH INPUT
MODE MODE AUTO AUTO MULT MULTI
A/B
T-MODE MEMORY CLEAR
DISPLAY
EXIT
SPEAKERS MRAC
AUTO TUNE
1.
SR9600N DFU_01_ENG 4_4 05.5.23, 5:57 PM Page 57 Adobe PageMaker 6.5J/PPC