beautypg.com

Settings, Setting id number for f.c.b.s, Setting the power amp direct mode – Marantz PM-14S1 User Manual

Page 26

background image

18

ENGLISH

Settings

INPUT SELECTOR

DISPLAY

P.DIRECT IN

X

Setting ID number for F.C.B.S

When the unit is turned on, the display shows the ID number

for three seconds.

For a master unit, ID number 1 needs to be assigned.

For a slave unit, set any of ID numbers 2 to 4.

1

While holding DISPLAY on the unit, press

X

.

2

Turn INPUT SELECTOR on the unit to select an

ID number.

3

Turn the unit off.

4

Again turn the unit on.

• The setting is saved.

• The unit registered as a slave shows “SLAVE” on the

display.

NOTE

• If using this unit by itself as a stereo amplifier, set the ID

number to “0” (Default setting is “0”).

• If the ID number is set to a number other than “0”, this unit

cannot be used for standalone operation.

Setting the power amp direct mode

When a pre-amplifier is connected to this unit and the unit is

used as a power amplifier, follow the instructions below to

turn power amp direct mode on.

• The power amp direct mode is turned off in the factory

default settings.

Turning power amp direct mode on

Press and hold P.DIRECT IN on the unit for 3

seconds or longer.

“POWER AMP DIRECT” is appears on the display .

Turning power amp direct mode off

Press and hold P.DIRECT IN on the unit for 3

seconds or longer.

“POWER AMP DIRECT” disappears from the display.

NOTE

• When the power amp direct mode is on, adjustment of the

volume, balance and tone on the main unit has no effect.

Adjust the volume on the pre-amplifier.

• When the power amp direct mode is on, the main unit outputs

at maximum volume. Check the output level on the input

device before playing it and adjust the volume accordingly.

1.PM14S1N_ENG_Final_0708.indd 18

2013/07/11 19:14:18