Marantz PM-14S1 - Manual (Page 15)

7
Playback
Settings
Tips
Appendix
ENGLISH
Connections
Preparation
NOTE
• Disconnect this unit’s power plug from the power outlet before connecting the speakers.
• Connect the speaker cables so they do not stick out of the speaker terminals. The protection
circuit may be activated if the wires touch the rear panel or if the + and – sides touch each
other (vpage 24 “Protection circuit”).
• Never touch the speaker terminals while the power cord is connected. Doing so could result
in electric shock.
• Use speakers with an impedance of 4 – 8 Ω/ohms.
Cables used for connections
Provide necessary cables according to the devices you want to connect.
Speaker cable
Audio cable
R
L
R
L
Remote connector cable
Connections
Connecting the speakers
Connecting the speakers cables
Carefully check the left (L) and right (R) channels and + (red) and – (white) polarities on the
speakers being connected to the unit, and be sure to connect the channels and polarities
correctly.
1 Peel off about 10 mm of sheathing from the tip of the speaker
cable, then either twist the core wire tightly or apply solder
to it.
2 Turn the speaker terminal counterclockwise to loosen it.
3 Insert the speaker cable’s core wire to all the way into the
speaker terminal.
4 Turn the speaker terminal clockwise to tighten it.
Spade lug connector
1.PM14S1N_ENG_Final_0708.indd 7 2013/07/11 19:14:06