beautypg.com

Connecting p.direct in connectors, Connecting pre out connectors – Marantz PM-14S1 User Manual

Page 22

background image

14

ENGLISH

Connecting P.DIRECT IN connectors

If you use a pre-amplifier, connect it as shown below, and then you can use this unit as a power

amplifier.

Press and hold P.DIRECT IN on the unit for 3 seconds or longer.

• The power amp direct mode setting changes with each press of the button.

• If the mode is set to on, the display shows “POWER AMP DIRECT”.

On : Allows the device connected to the Power Amp Direct connector to be played.

Off (Default): Allows the program source selected using INPUT SELECTOR to be played.

(R)

(L)

L

R

L

R

Pre-amplifier

Speakers

To PRE OUT connectors

NOTE

• When the power amp direct mode is on, adjustment of the volume, balance and tone on the

main unit has no effect. Adjust the volume on the pre-amplifier.

• When the power amp direct mode is on, the main unit outputs at maximum volume. Check

the output level on the input device before playing it and adjust the volume accordingly.

Connecting PRE OUT connectors

If you use a power amplifier, connect it as shown below, and then you can use this unit as a

pre-amplifier.

• For connecting speaker systems, refer to the owner’s manual supplied with the power

amplifier to be used.

Power-amplifier

R

L

R

L

To input connectors

NOTE

The power amp direct mode and the PRE OUT function cannot work at the same time.

1.PM14S1N_ENG_Final_0708.indd 14

2013/07/11 19:14:12