Dixon 6520-1099 - Manual (Page 32)

Page 32
CARE AND MAINTENANCE
DECK REMOVAL - ELECTRIC CLUTCH
MODEL ZTR 3014
1. Place cut height lever in lowest cut position.
2. For 36" decks, loosen nut on belt idler shock mount until belt can be removed from
electric clutch pulley on the bottom of the engine. Refer to illustration below.
For 42" decks, pull belt idler back to allow belt to be removed from idler pulley and
electric clutch pulley.
3. Remove hair pin cotter and washer from one end of deck support cross shaft. Note
location of remaining shim washers used between chassis and mower deck pan
arms. Slide shaft from chassis and mower deck.
4. Remove hair pin cotter and washer from each deck adjustment rod. Carefully push
each link toward the inside of the mower chassis. At this point, deck will drop
down.
5. Carefully raise and support front of chassis. Slide mower deck to either side for
removal. (Reverse procedure to reinstall deck assembly).