Controls – Dixon 6520-1099 User Manual
Page 22
Page
22
BLADE DRIVE:
Models ZTR 3303 & 3304
Located to left of operator.
To engage the mower blade, turn lever on floor
slowly to the "ON" position.
To disengage mower blade, turn lever to the
"OFF" position.
BLADE DRIVE:
Model ZTR 3014
Located on control panel, on operator's right.
To engage the mower blades, pull up on the
switch.
To disengage blades, push down.
CIRCUIT BREAKER:
Protection of the electrical system is by
(1) 15 amp circuit breaker.
If circuit breaker trips, push button to reset.
If this condition repeats, consult dealer for
inspection and repair.
MOWER DECK CUT HEIGHT LIFT LEVER:
Located to left of operator.
Controls the cutting height.
Seven positions of adjustment.
Move lever in and forward to lower.
Move lever in and back to raise.
NOTE: Always use high for transport.
CONTROLS