Specifications – Dixon 6520-1099 User Manual
Page 3
Page
3
SPECIFICATIONS
Model ZTR 2301
CHASSIS:
Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
BODY:
All body parts are made of rotational molded polyethylene. Front body
contains access panel for battery service. Seat tilts forward to allow
transmission service.
MOWER DECK:
11 GA stamped steel construction.
Single 30" cut blade.
Cut height approximately 1" to 4" via 7 position lift handle.
BLADE DRIVE:
Mechanical; hand lever engagement.
TRANSMISSION:
Each rear wheel is independently driven by chain and sprockets through a
friction mechanical drive.
ENGINE:
16 HP Kohler Command 16, 4-Cycle, Single Cylinder, Overhead Valve, Air-
Cooled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft,
Aluminum Head and Block with Cast-Iron Cylinder Liner. Smart Spark
Ignition.
STARTING SYSTEM:
Electric by key switch operation with safety interlocks on parking brake and
blade drive.
TIRES:
Front
11 X 4.00-5 ribbed tread.
Rear
16 X 6.50 X 8 Multi-Trac.
RECOMMENDED
Front
16-21 PSI.
TIRE PRESSURE:
Rear
8-14 PSI.
CAPACITIES:
Fuel
2.0 gallons total.
Engine
1.25 quarts oil.
DIMENSIONS:
Width
32.5" outside rear wheel measurement.
Height
32.0" to top edge of seat.
Length
65.5" hitch tab to front bumper.
Weight
440 lbs.
NOTE:
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.