Dixon 6520-1099 - Manual (Page 17)

Page 17
SPECIFICATIONS
Model ZTR 3014
CHASSIS: Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
BODY: All body parts are made of rotational molded polyethylene. Front body contains
access panel for battery service. Seat tilts forward to allow transmission service.
MOWER DECKS: 36" Deck: 11 GA Laser Cut Fabricated - 36" Cut Width
42" Deck: 13 GA Stamped Steel Construction - 42" Cut Width
Cut height approximately 1" to 4" via 7 position lift handle.
BLADE DRIVE: Electric clutch.
TRANSMISSION: Each rear wheel is independently driven by chain and sprockets through a
friction mechanical drive.
ENGINE: 14.5 HP Briggs & Stratton OHV I/C Quiet, 4-Cycle, Single Cylinder, Air-
Cooled, Gasoline, Vertical Shaft, Cast Iron Cylinder, Synchro-Balanced,
Laminated Shroud.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake and
blade drive.
TIRES: Front 11 X 4.00 -5 ribbed tread.
Rear 18 X 8.50 X 8 Multi Trac tread.
RECOMMENDED Front 16-21 PSI
TIRE PRESSURE: Rear 8-10 PSI
CAPACITIES: Fuel 2.0 gallons total.
Engine 1.25 quarts oil.
DIMENSIONS: Width 43.0" outside rear wheel measurement.
Height 36.0" to top edge of seat.
Length 65.5" hitch tab to front bumper.
Weight 36" Deck: 500 lbs. 42" Deck: 520 lbs.
NOTE: Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.