Louroe Electronics DG-12II - Manual (Page 17)

PAGE 14 of 28
CONNECTION TO A DVR, VCR OR OTHER RECORDING DEVICE:
Remove the jumper (FIG.9A) that connects the Audio Input Jack[38] to the Audio
Output Jack [39] located at the rear of the DG-MA. Using a dual RCA cable, connect the
Audio Input Jack[38] of the DG-MA to the Audio Output Jack of the recorder. Connect
the Audio Output Jack[39] of the DG-MA to the Audio Input Jack of the recorder. See
Fig. 9 below.
Fig. 9 Connecting to a Receiving Device
Fig. 9A Jumper Connection
INPUT
OUTPUT
AUDIO
IN OUT
RECEIVING DEVICE
RCA CABLES
REAR OF DG-MA
INPUT
OUTPUT
AUDIO JUMPER
REAR OF DG-MA
AUDIO
NOTE:
If DG-MA is not connected
to a recording device,
jumper must be plugged
into the audio input and
output. Otherwise DG-MA
will not receive audio from
the remote microphone.
DG_12II_6/11
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
INSTALLATION AND OPERATING INSTRUCTIONS