Louroe Electronics TLO-NM - Manual

DESCRIPTION
SPEAKER CONNECTION OF TLO-NM
The TLO-NM is a speaker horn for high volume penetration.
Commonly used for outdoor use, In operation, the TLO-NM
provides talkback capabilities between the remote zone and
Louroe base station, or with other compatible audio transmitting
devices such as an AOP-SP70.
MODEL TLO-NM
Speaker connection is located near the rear of the TLO-NM and has a plexiglass window. Remove window and connect 2
cond unshielded 18 Ga wire (see diagram) to the two terminal screws marked 1 and 2.
White speaker wire goes to position 2 (positive)
Black speaker wire goes to position 1 (negative)
POWER TAP SETTINGS
Located above the speaker connection is a set screw with a dial numbered 1 through 7. Using a small screw
driver, adjust the set screw to correspond to the proper power tap setting with the following Louroe audio base
stations.
IF TLO-NM IS CONNECTED TO BASE STATION MODELS:
AP-1TB through AP-16TB #1 1.8W
DG 12II and DG 25III 1 TLO-NM per zone #4 15.0W
2-4 TLO-NM’s per zone using MLA-6 Mixer #2 3.7W
If TLO-NM is to be connected to Louroe AOP-SP70 conversion unit #2 3.7W
for interfacing with a DVR or PC Soundcard, use setting
Setting Wattage
1 2
1
2
3 5
6
7
Speaker connection
(BLACK-negative)
Speaker connection
(WHITE-positive)
1 through 7
power tap settings
set screw
TLO-NM
OUTDOOR SPEAKER
INSTALLATION AND OPERATING INSTRUCTIONS
Page 1 of 4
tlo-nm inst 3/15
6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
/ www.louroe.com [email protected]
®