Lencore n.Form: Installation and Operations Manual - Manual (Page 27)

section 3
3.8 | wiring information
2
3
4
1
Connect the CAT 5 Speaker cable to the IN jack designated at the bottom
of the speaker can.
TEST CABLES BEFORE INSTALLING – USE APPROPRIATE CABLE TESTERS
Run CAT 5 Speaker cable from the OUT jack of the same speaker can to the
next corresponding IN jack of the next speaker for that channel.
Continue this sequence until all of the speakers in the channel run are
completely wired.
There will be nothing connected to the last speaker on the OUT port and
the end of each designated channel.
NOTE
Keep channels EXACTLY
as marked on drawing.
24
ALL CAT 5 cables MUST be tested, even if the cables are pre-packaged and labeled as
tested! We cannot stress this enough as pre-certified cables are often batch tested and
there may be cables that have not been tested and can fail!