Lencore n.Form: Installation and Operations Manual - Manual (Page 19)

section 3
3.3 | hang speakers
1
2
3
4
Climb ladder and access the ceiling plenum
Hang speaker units in plenum area at marked locations using preferred hanging method
(powder action gun such as a Hilti-gun™ or drill and screw; check your local building codes
for allowable hanging methods and standards)
Drive a nail holding the clip with the speaker chain and speaker into ceiling
Pull and connect audio cables to speakers by channel (refer to Section C Wiring)
CAUTION
Follow channel
designations on drawings
(1,2, 3,…8) so that proper
tuning of the system can
take place. Any changes to
the system MUST be
designated on the drawing
* Hilti™ is a trademark of Hilti Corp., FL – 9494 Schaan, Principality of Liechtenstein © 2001 – 2007,
Right of technical and programmed changes reserved, S.E. & O.
16
NOTE: If installing inline speakers, make sure the potentiometer on the bottom of the speaker
is set to the MAXIMUM (clockwise) setting.