Lencore n.Form: Installation and Operations Manual - Manual (Page 25)

At the last Emerald OP:
Run the last data cable to the IN jack of the last Emerald OP in
the project.
In the last Emerald OP, run a cable from the data OUT to the head end
equipment in the data closet. This will connect to the data IN from
the last Emerald OP on the SmartSwitch.
In the last Emerald OP, click the Audio Terminator into the Audio
OUT jack. This should only be installed in the last Emerald OP.
section 3
3.7 | data and audio cables
1
a
b
c
22