Delta 36-714 - Manual (Page 9)

9
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
* Phillips head screw driver (not supplied)
* ½”, 13mm, 5/8”, 3/8” open end wrenches (not supplied)
* Other wrenches and a drill with a 1/4 inch bit may be required, depending on what fence or tables will be used
ASSEMBLY TIME ESTIMATE - 2 to 3 hours
Fig. 2A
For your own safety, do not connect the machine to the power source until the machine is completely
assembled and you read and understand the entire instruction manual.
The saw is extremely heavy. have two or more people help lift and move machine around during
assembly.
1
2
9
12
11
13
19
20
Fig. 2
Fig. 2 Parts
1. 7 /
16
"-20 x 1 1 /
4
" Hex Head Screw (6)
2. 7 /
16
" Flat Washer (6)
3. 7 /
16
" Lock Washer (6)
4. M8x30 Hex Head Screw (1)
5. M8
Nut (1)
6. M8 lock washer (1)
7. M8 flat washer (1)
8. M8 Washer (2)*
9. M8x25 Hex Head Screw (2)*
10. M8 Lock Washer (2)*
11.
1 /
4
”-20x 3 /
8
” Round Head Tap Screw (8)
12. M4 x 10mm Round Head Screw (6)
13.
1 /
4
"-20 x 3 /
4
" Hex Head Screw (2)
14. 1 /
4
" Flat Washer (2)
15. 1 /
4
" Lock Washer (2)
16. 5 /
16
"-18 x 5 /
8
Carriage Head Screw (1)
17. 5 /
16
" hex nut (1)
18. 5 /
16
" flat washer (1)
19. Nylon Washer (2)
20. M5x20mm Screw (1)
21. Washer for Miter Gage (1)
* Parts 8, 9 and 10 are included to attach the
rear rail of the fence to the table of this saw.
5
4
3
8
14
15 16
18
17 21
6
7 10
UNPACKING AND CLEANING
Carefully unpack the machine and all loose items
from the shipping container(s). Remove the rust-
preventative oil from unpainted surfaces using a soft
cloth moistened with mineral spirits, paint thinner or
denatured alcohol.
Do not use highly volatile solvents such
as gasoline, naphtha, acetone or lacquer thinner for
cleaning your machine.
After cleaning, cover the unpainted surfaces with a
good quality household floor paste wax.
The basic saw unit is shown as shipped here in Fig.
2A.