Example #3 example #4 – Kreg PRS1200 Precision Beaded Face-Frame System User Manual
Page 11

Example #3 Example #4
11
24”
12-1/2”
13”
5”
3” Rail
1-1/2” Rail
15”
1-1/2” Rail
3/4”
7.-1/4”
3/4”
1-1/2”
2-1/4”
STILES
• First cut at 0” to trim away end material.
Repeat on both ends.
• Second cut at ¾” marking, indicating center of top
and bottom rails. Repeat on both ends.
• Third cut at 8-1/4” marking, indicating center of the
two middle rails. Repeat on both ends.
Rails
• Set your stop at ½” on the left side of the bit.
• Trim all 4 corners of the 2 middle rails and the
inside 2 corners of the top and bottom rails.
STILES
• First cut at 0” to trim away end material. Repeat
on both ends.
• Second cut at ¾” marking, indicating center of top rail.
Repeat on both ends.
• Third cut at 1-1/2” marking, on the bottom of the
stile only.
• Fourth cut at 2-1/4” marking, on the bottom of the
stile only.
• Fifth cut at 7-1/4” marking, indicating center of the
middle rail.
• By purchasing a larger Notching Bit in addition to the
¼”x1-1/2” Notching Bit included with this product, you
can use it to reduce the number of cuts required.
Rails
• Set your stop at ½” on the left side of the bit.
• Trim all 4 corners of the middle rail and the inside
2 corners of the top and bottom rails.
24”x15” three-drawer-bank face frame. 1-1/2” stiles
and rails. 3 – 6” drawer bank openings.
Basic 24”x15” face-frame. 1-1/2” top and middle rails,
3” bottom rail, 1-1/2” stiles. 5” drawer bank opening and
13” door opening.
3/4”
24”
6”
6”
6”
15”
12-1/2”
6x
1-1/2” Rails
8-1/4”
3/4”
8-1/4”