Kreg PRS1200 Precision Beaded Face-Frame System - Manual (Page 10)

Example #1 Example #2
10
Basic 24”x15” face-frame. 1-1/2” stiles and rails,
5” drawer bank opening and 14-1/2” door opening.
Basic 24”x15” face-frame. 2” rails, 1-1/2” stiles.
5” drawer bank opening and 13” door opening.
STILES
• First cut at 0” to trim away end material. Repeat
on both ends.
• Second cut at ¾” marking, indicating center of top
and bottom rails. Repeat on both ends.
• Third cut at 7-1/4” marking, indicating center of
middle rail.
Rails
• Set your stop at ½” on the left side of the bit.
• Trim all 4 corners of the center rail and the inside
2 corners of the top and bottom rails.
STILES
• First cut at 0” to trim away end material. Repeat
on both ends.
• Second cut at 3/4”. Repeat on both ends.
• Third cut at 1-1/4” marking. Repeat on both ends.
• Fourth cut at 7-3/4” marking, to cut the top half of the
middle rail.
• Fifth cut at 8-1/4” marking, to cut the bottom half of
the middle rail.
• By purchasing a ¼”x2” Notching Bit in addition to the
¼”x1-1/2” Notching Bit included with this product, you
can use it to reduce the number of cuts required.
Rails
• Set your stop at ½” on the left side of the bit.
• Trim all 4 corners of the center rail and the inside
2 corners of the top and bottom rails.
15”
3/4”
7.-1/4”
3/4”
24”
12-1/2”
5”
14-1/2”
1-1/2” Rails
7-3/4”
3/4”
12-1/2”
24”
13”
5.”
15”
2” Rails
1-1/4”
8-1/4”
3/4”
1-1/4”