Kip multi-touch user guide – KIP Multi-Touch User Manual
Page 28
KIP Multi-Touch User Guide
No part of this publication may be copied, reproduced or distributed in any form without express written permission
from KIP. 2015 KIP. v1
- 28 -
Step
Action
Illustration
11.
Finishing – Select from available
finishing devices attached to the
KIP Printer.
Default - Output is sent to the
default stacking device.
Rear – The output can be forced
to go to a rear stacker.
Top – The output can be forced to
go to the top stacker.
Folding/No Folding – If a folder is
attached, the output can be sent
to the folder.
12.
Mirror – When selecting Mirror,
the image will be printed with a
mirrored output.
13.
Stamp - Select “Stamp” to allow
the selection of a “Stamp” or
“Water Mark” to be placed on
the scanned image. It will be
embedded digitally into the
image.
Note: Creation of new stamps will
be done through KIP PrintPro.Net