Warning – Kiddy Click'n move 3 User Manual
Page 21
EN
21
4.6.3 Height adjustment of the shoulder belts
Open the velcro on the backside of the backrest.
Push the plastic clip from the backside of the backrest through the hole to the
front.
Do the same on the second side.
Now insert the plastic clip into the hole in the required height (fig. 20).
WArnInG
the plastic clip must lay flat on the backside of
the backrest.
WArnInG
Make sure that both shoulder belts are fixed in
the same height.
4.7 removing/re-installing the 5-point belt system
Open the Velcro behind the back rest and on the lower side of the seat part
(fig. 21).
Put one hand under the cover and thread the end clip of buckle belt through the
hole of seat plate (fig. 22; no. 1). Then thread both end clips of hip belts through
the lower holes of backrest. (fig. 22; no. 2). Then thread both end clips of the
shoulder belts through the upper holes of back rest (fig. 22; no. 3).
To re-install the 5 point belt system, follow the steps for removing the belt system
in reverse order.
21