Reinitiating an emergency mode, Exiting an emergency mode, Advanced features – Motorola DP 2400 User Manual
Page 43
Advanced Features
English
35
4
The radio automatically stops transmitting when:
Once the cycling duration between hot mic and receiving
calls expires, if Emergency Cycle Mode is enabled.
OR
Once the hot mic duration expires, if Emergency Cycle
Mode is disabled.
5
To transmit again, press the PTT button.
OR
Press the programmed Emergency Off button to exit the
Emergency mode.
If your radio is set to Silent, it will not display any audio or visual
indicators during Emergency mode, or allow any received calls
to sound through the radio’s speaker, until the programmed hot
mic transmission period is over, and you press the PTT button.
If your radio is set to Silent with Voice, it will not display any
audio or visual indicators during Emergency mode when you
are making the call with hot mic, but allow sound through the
radio’s speaker when the target radio responds after the
programmed hot mic transmission period is over. The indicators
will only appear when you press the PTT button.
NOTE: If the Emergency Alarm request fails, the radio does
not retry to send the request, and enters the hot mic
state directly.
Reinitiating an Emergency Mode
NOTE:
This feature is only applicable to the radio sending the
Emergency Alarm.
There are two instances where this can happen:
•
You change the channel while the radio is in Emergency
mode. This exits the Emergency mode. If Emergency Alarm is
enabled on this new channel, the radio reinitiates Emergency.
•
You press the programmed Emergency On button during an
Emergency initiation/transmission state. This causes the
radio to exit this state, and to reinitiate Emergency.
Exiting an Emergency Mode
NOTE: This feature is only applicable to the radio sending the
Emergency Alarm.
Your radio exits Emergency mode when one of the following
occurs:
•
Emergency Alarm acknowledgement is received (for
Emergency Alarm only), OR
•
An Emergency Exit Telegram is received, OR
•
All retries to send the alarm have been exhausted, OR
•
The Emergency Off button is pressed.
•
Turn the radio off and then power it on again if your radio has
been programmed to remain on the Emergency Revert
channel even after acknowledgement is received.
NDP_ANZ-EMEA.book Page 35 Thursday, July 19, 2012 8:22 AM