Kleenmaid TX768A - Manual (Page 6)

6
Installing the machine
Connecting up your machine
Moving the machine
using the castors
To extend the castors, move the lever at
the bottom of the machine from right to left
(Diagram 6).
The machine should not be used while
standing on its "front" castors: do not forget
to return the lever to its original position.
Levelling
Use a spirit level to check that the ground
is horizontal: the maximum allowable slope
is 2° which gives a difference in height of
about 1 cm across the width of the machine
and 1.5 cm from front to rear.
Cold water supply
Connect up the hose (Diagram 7):
- connect the 90° elbow end to the union
at the back of the machine;
- connect the other end to a tap fitted with
a threaded end diameter 3/4 BSP, not
forgetting to insert the filter washer
supplied in the bag of accessories.
Diagram 6
Diagram 7
Water inlet :
- Minimum water pressure: 70 kPa
- Maximum water pressure : 1000 kPa