Kleenmaid TX768A - Manual (Page 5)

5
Unpacking your machine
Please keep all packing components as they must be replaced if the machine is
to be shipped elsewhere
All these parts and the components of your machine are made of recyclable
materials. Please bear this in mind when the time comes to dispose of your machine
Your machine was inspected before leaving the factory. You may therefore find traces
of water in the tank or in the detergent compartment
Installing the machine
We advise against installing your machine on a carpeted floor. If this is unavoidable,
take all precautions to avoid preventing air circulation at the base, to ensure that
the internal parts are well ventilated.
Machine location
If you locate your machine next to another
appliance or an item of furniture, you should
leave space between them to allow air to
circulate (Diagram 5).
Diagram 5
5 - Remove the block that immobilises the
drum and tub (Diagram 3).
To do this:
- raise the machine lid;
- if your machine comes with a packing
wedge «F», remove it;
- remove the block «G» by rotating it
through 90°;
- open the doors of the drum which are
locked in the low position, by pushing
both flaps at the same time.
6 - Lift up the hoses support clamps
➀
and
do not fall to block the holes using
plugs
➁
(provided in the accessories
bag) (Diagram 4).
Diagram 3
a
b
a
b ➀
➁
Diagram 4
F
G