Kleenmaid TX768A - Manual (Page 4)

4
Unpacking your machine
BEFORE ATTEMPTING TO USE THE MACHINE, YOU MUST FOLLOW THE PROCEDURE
DESCRIBED BELOW
These operations involve removing the metal transit bracket and the blocks which
immobilise the tank of your machine during the transportation, as well as the supports
which hold up the hoses and the electric cable.
These operations, known as "unpacking", are necessary for your machine to
operate correctly and also for complying with current safety standards.
1 - Remove the washing machine from its
base (check that the block «A» that
retains the motor is not stuck under
the machine) (Diagram 1)
2 - Remove the four screws «B» with a
screwdriver (Diagram 2.1)
3 - Remove the bracket «C» by removing
the two bolts «D» with a 13 mm spanner
(Diagram 2.2)
(Make sure that the two plastic
spacers attached to the bar are
removed at the same time).
Replace screws «B» in their original
position.
4 - Blank off the two holes using the plugs
«E» (provided in bag of accessories)
(Diagram 2.3)
Diagram 1 Diagram 2.1
Diagram 2.2
Diagram 2.3
13
1
1
2
2
A