Kleenmaid TX768A - Manual (Page 17)

17
Routine maintenance
Cleaning the “debris trap”
This clever system traps any small debris
you might have overlooked in the clothes
and prevents it from damaging the pump.
To clean the trap:
- rotate the drum so that the closed flaps
are at the bottom: you will see a plastic
part «A» (Diagram 14)
- if it is fitted on your machine, remove
screw «B»
- on some types of machine, part «A» is
provided with a clip «C». If this is the
case, unlock part «A» by applying
pressure to the clip while gently sliding
it to the right
- then, in all instances: turn the drum again,
open the doors and remove part «A» by
sliding it in the direction of the arrow
- then rotate the drum slightly with the flaps
open, towards the front of the machine.
You then have access to the "debris trap"
(Diagram 15)
- remove it from its housing
- remove any items from the inside
- rinse it under the tap (Diagram 16)
- replace it, pushing it firmly into its housing
after first checking that the housing is
clean
- refit the plastic part «A» and bolt «B» by
following the above procedure in the
reverse order.
Periodic checks
You should check the condition of the
water inlet and drain hoses. If you find any
splits in the hoses, however minor, do not
hesitate to replace them with identical
hoses that can be obtained from Kleenmaid
Spare Parts.
It is necessary to check that the hose
connections on the taps and the rear of the
machine have not worked loose and started
to leak. Tighten if necessary.
Diagram 16
Diagram 14
Diagram 15
C
B
A