Kleenmaid KFL850 - Manual (Page 25)

24 25
Failure Possible cause Remedy
The machine does not
work (indicator LED’s
are not illuminated).
Machine is not powered. Check if:
• power in the socket,
• the fuse is OK,
• plug is in the socket.
Washing program
does not start (WASH
LED flashes twice).
Door is not properly closed. Push it towards the machine.
Water does not enter
the machine (after
approx. 8 min the
machine reports
failure).
Disturbed water inlet. Check if:
• the water tap is open,
• inlet hose filter is clean.
Push the START button.
Water is leaking from
the machine.
Filter is not tightly screwed in.
Inlet hose is not tightly screwed
to the machine or to the water
tap.
Outlet hose has dislodged.
Tighten the filter properly.
Tighten the inlet hose.
Affix the outlet hose to the drain.
The machine moves
during operation.
The machine is not properly
levelled.
Transport brackets are not
removed.
Level the machine with the adjustable
legs.
Remove transport brackets.
The machine vibrates
during the spin.
Unevenly distributed laundry,
especially with very small
quantities.
This is normal, the machine will
reduce the RPM if vibrations are too
strong.
Wash larger quantity of laundry.
Excessive foaming
during washing.
Excessive measure of detergent. Use washing powder according to
the manufacturers instructions and
according to water hardness and the
amount of soiling of the laundry.
Use only detergents for machine
washing.
Water is poorly
pumped out or not at
all (machine reports
failure).
Water outlet is clogged. Check if:
• the filter is clean,
• outlet hose is not jammed,
• outlet hose is positioned higher than
1 m.
Push START again.
Laundry is not
properly spun.
No failure is reported.
The machine switched on the
UKS* function. Because of
uneven laundry balance, the
machine has automatically
reduced the spin RPM.
The machine operates normally.
Wash large and small pieces of
laundry together.