Kleenmaid KFL850 - Manual (Page 24)

The washing machine automatically monitors the
execution of particular functions during the operation,
and reports any detected failures. In such cases
both signal LED’s start flashing in certain sequence,
accompanied by the audible signal, sounding in the
same sequence as the indicator LED’s flash. The
flashing sequence changes in accordance with the
nature of the detected failure.
In some cases you may attempt removing certain
failures yourself.
The machine signals failures immediately after
detecting them and stops the program, except for
heater failure, where the machine completes the
washing program without heating water.
Failures
In certain cases you may remove the failure yourself.
If the WASH LED flashes twice check the door is
closed correctly.
Before calling for service check the following
troubleshooting charts on Page 25 & 26 of the
manual. If you are still unable to remedy the fault call
your nearest authorised service centre on
1300 652 100.
Service calls resulting from any failure arising due to
customer error or not checking the troubleshooting
chart are not covered by warranty and any repair
expenses are to be paid by the customer.
LED’s continue flash until the machine is switched off.
Interferences from the ambient (for example electrical
wiring) could induce signalization of different faults. In
such cases:
- switch the appliance off, and wait for a few seconds;
- switch the appliance back on and repeat the
washing program.
If the fault repeats, call authorized service shop.
24 25
Failures