Kleenmaid TO701 - Manual (Page 9)

9
l l y o u r o v e n
We cannot accept any liability in the event of an accident
resulting from non-existent or faulty earthing.
• Open the trapdoor at the bottom right hand side at the back of the oven by
removing the 2 screws and swinging the door away.
• Remove the sheath from each wire in the new cable up to 12 mm.
• Twist the ends carefully together.
• Unscrew the terminal screws and remove the wires that need changing.
• Pass the new cable through the wire clamp to the right of the terminals.
• Connect the wires up in accordance with the markings on the terminals.
• Make sure all wires are trapped under the screws.
• The brown wire (live) going to terminal marked L.
• The green and yellow wire (earth) going to the one marked
.
• The blue wire (neutral) going to the terminal marked N.
• Tighten the screws and check, by tugging on each wire, that they are firmly connected.
• Tighten the clamp to hold the cable.
• Close the trapdoor using the two screws.
The electrical connections are made before the oven is installed in its housing.
• The oven must be connected using an approved 3-core cable (live, neutral and
earth ) of sufficient size to carry the rated current of the oven. This should be
connected via a 3- pin socket (live, neutral, and earth to the main supply which
should be should be a 220-240V, alternating single-phase current. If the oven is
not connected using a plug and socket, it must be connected to a multi-pole switch
with a minimum gap of 3 mm between contacts. The earth wire (green and yellow)
should be connected to the terminal marked with the earth symbol on the
appliance and to the earth in the switch.
• Where the oven is connected using a separate plug and socket this must be
accessible after the oven has been installed.
• The neutral wire (blue) of the oven must be connected to the neutral in the main supply.
F itting new wiring and/or changing cables.
99629211_GB_A.qxd 16/06/03 10:27 Page 9