Kemppi Promig 200 - Manual (Page 20)

20 – PROMIG 200, PROMIG 300 / 0537 © KEMPPI OY
7. TECHNICAL DATA
Promig 200 Promig 300
Working voltage (safety volt.) 50 VDC 50 VDC
Rated power 100 W 100 W
Max. load
(nominal values) 60 % ED 460 A 460 A
100 % ED 355 A 355 A
Operation principle 4 roll feed 4 roll feed
Diameter of feed roll 32 mm 32 mm
Wire feed speed I 0...18 m/min 0...18 m/min
Wire feed speed II ¹) 0...25 m/min
Filler wires ø Fe, Ss 0,6...1,6 0,6...1,6
ø Cored wire 0,8...1,6 0,8...2,0
Wire reel max. weight 5 kg 20 kg
max. size ø 200 mm ø 300 mm
Torch connector Euro Euro
Operation temperature range 20...+40 °C -20...+40 °C
Storage temperature range -40...+60 °C -40...+60 °C
Degree of protection IP 23 IP 23
Dimensions with safety frame
length 500 mm 600 mm
width 230 mm 225 mm
height 315 mm 415 mm
Weight 13 kg 17 kg
The products meet conformity requirements for CE marking.
1) Changes of speed are carried out by changing rear wheel and jumper block
selection on circuit card A001.
Liquid-cooled:
PMT 30W 3 m 6253043
PMT 30W 4,5 m 6253044
PMT 42W 3 m 6254203
PMT 42W 4,5 m 6254204
PMT 52W 3 m 6255203
PMT 52W 4,5 m 6255204
MMT 30W 3 m 6253043MMT
MMT 30W 4,5 m 6253044MMT
MMT 42W 3 m 6254203MMT
MMT 42W 4,5 m 6254204MMT
MMT 52W 3 m 6255203MMT
MMT 52W 4,5 m 6255204MMT