3 parameter guides, Mig/mag welding – Kemppi RA User Manual
Page 26
EN
5.3 parameter guides
Fe 0.8 mm, 5 – 18 % CO₂/Ar
PlateThickness
mm
0.5
0.8
1
1.5
2
2.5
3
WireFeedSpeed
m/min
2
2.5
3.5
5
8
10
13
SetVoltage
V
14.5
15
15.5
16
17
18
20
MeanCurrent
A
40
50
65
97
130
155
185
Fe 1.0 mm, 5 – 25% CO₂/Ar
Plate Thickness
mm
0.7
1.5
2
3
4
5
Wire Feed Speed
m/min
1.4
3.2
4.5
6.5
8.5
11.0
Set Voltage
V
15.0
17.5
18.4
21.4
23.8
28.8
Mean Current
A
40
100
150
180
200
240
Fe 1.2 mm, 5 – 25% CO₂/Ar
Plate Thickness
mm
1
1.5
2
3
4
6
Wire Feed Speed
m/min
1.5
2.2
3.2
5.0
6.0
7.2
Set Voltage
V
14.6
17.0
17.8
21.0
22.7
26.3
Mean Current
A
75
100
140
180
220
250
6.
mig/mag Welding
NOTE!
Welding fumes may be dangerous to your health. Ensure that there is ample ventilation
during welding! Never look at the arc without a face shield specifically designed for arc welding!
Protect yourself and your surrounding area from the arc and hot welding spatter!
NOTE!
Always wear protective clothing, gloves, face and eye shields suitable for welding. It is
recommended that you make practice welds before you commence welding your main work piece.
NOTE!
The work piece will be very hot. Protect yourself and others at all times.
You can start welding after you have made the necessary preparation described throughout
these instructions.
Providing you ensure that the equipment is correctly prepared and set for the material type
and joint to be welded, you will achieve exceptionally high quality welding results.
• Ensure that the correct filler wire type and size is selected for the work piece.
• Ensure that the correct wire liner and contact tip size is fitted to the welding gun.
• Ensure that the correct shielding gas type is connected and the flow rate adjusted before
welding starts.
• Ensure the earth return clamp is connected to the work piece
• Ensure that you are wearing the correct safety equipment before you start welding
– including: suitable welding clothing, the correct welding face shield with a suitable
shade welding lens, welding gloves and when necessary, a welding mask.
NOTE!
Please read section 1.2.2 before proceeding further.
Kempact RA 181A, 251R, 251A, 253R, 253A, 253RMV, 253AMV, 323R, 323A, 323RMV, 323AMV
24