Jetway Computer NMF95-Q87 - Manual (Page 33)

29
USB Configuration
XHCI Mode
Use this item to select mode of operation for XHCI controller.
The optional settings are: [Smart Auto]; [Auto]; [Enabled]; [Disabled]; [Manual].
*When set as [Disabled], the following sub-items shall appear:
EHCI1/EHCI2
Use this item to control the USB EHCI (USB 2.0) functions.
One EHCI controller must always be enabled.
*When set as [Manual], the following sub-items shall appear:
Route USB 2.0 pins to which HC?
The optional settings are: [Route Per-Pin]; [Route all Pins to EHCI]; [Route all Pins
to XHCI].
Enable USB 3.0 pins
The optional settings are: [Select Per-Pin]; [Disable all Pins]; [Enable all Pins].
Azalia
This item control the detection of the Azalia device
The optional settings are: [Disabled]; [Enabled];[Auto].
[Disabled]: Azalia will be unconditionally disabled;
[Enabled]: Azalia will be unconditionally enabled;
[Auto]:Azalia will be enabled if present, disabled otherwise.
Onboard LAN1 Controller
Use this item to enable or disable onboard LAN1 controller.
*When set as [Enabled], user can also make further setting in the following item
that appears:
Wake on LAN1
Use this item to enable or disable integrated LAN to wake the system. The
Wake on LAN can not be disabled if ME is on at Sx state.
Onboard LAN2 Controller
Use this item to enable or disable onboard LAN2 controller.
SLP_S4 Assertion Width
Use this item to select a minimum assertion width of the SLP_S4# signal to ensure
that the DRAMs have been safely power-cycled.
The optional settings are: [Disabled]; [1-2 Seconds]; [2-3 Seconds]; [3-4 Seconds];
[4-5 Seconds].
Restore AC Power Loss
Use this item to select AC power state when power is re-applied after a power
failure. The optional settings are: [Power Off]; [Power On]; [Last State].

System Agent (SA) Configuration
Press [Enter] to make settings for the following sub-items:
VT-D
The optional settings are: [Enabled]; [Disabled].
*This item might not be available depending on configuration.
Azalia Internal HDMI Codec
Use this item to enable or disable DP/HDMI/DVI port audio device.
The optional settings are: [Enabled]; [Disabled].

Graphics Configuration