Ivoclar Vivadent Virtual 380 - Manual (Page 5)

– Cleaning of tray
Residue of adhesive material can be removed with alcohol.
Note the warnings in the Virtual Tray Adhesive Instructions for Use!
– Disinfection of impressions
Impressions made with Virtual impression materials can be immersed in a disinfection solu-
tion (glutaraldehyde 0.5%, benzalkonium chloride 0.5%). (Please observe the instructions of
the manufacturer.) The disinfection does not affect the surface or the dimension.
– Pouring up models
The impression may be poured immediately after disinfection, or up to two weeks later, pro-
vided that the impression is stored at room temperature. Dimensional stability is guaranteed
for 14 days, if stored appropriately. Virtual impression materials are compatible with all pop-
ular dental plasters on the market, e.g. Type 3: Modano
® (Heraeus Kulzer), Type 4: Fujirock ®
(G.C. International).
– Galvanization
Virtual impression materials can be silver or copper plated in a galvanic bath.
Special notes
Virtual impression materials should be at room temperature (23 °C / 73.4 °F) when processed.
Lower temperatures, e.g. when stored in the refrigerator, will prolong the time the impression
material should remain in the mouth, while higher temperatures will reduce the processing time
and the time the impression should remain in the mouth.
Vinylpolysiloxanes are chemically resistant. Unpolymerized materials may stain clothing.
Warnings
If uncured materials come into contact with the eyes, rinse the eye with copious amounts of
water. If irritation persists, seek medical attention. In case of contact with the skin, wash affected
areas with plenty of water.
Storage
– Storage temperature: 2–28 °C / 36–82 °F
– Shelf life: See expiration date on label and packaging
– Keep away from direct heat sources!
Keep out of the reach of children!
For use in dentistry only!
The material has been developed solely for use in dentistry. Processing should be carried out strictly according to
the Instructions for Use. Liability cannot be accepted for damages resulting from failure to observe the Instructions or
the stipulated area of application. The user is responsible for testing the products for their suitability and use for any
purpose not explicitly stated in the Instructions. Descriptions and data constitute no warranty of attributes and are
not binding.