Ivoclar Vivadent Monobond-S - Manual (Page 2)

instructions of the manufacturer of the restorative
material.
– Thoroughly rinse with water spray and dry with oil-
free air.
1.1.2 Lithium disilicate glass-ceramic restorations (e.g.
IPS e.max ® Press, IPS e.max CAD)
– Etch with 5% hydrofluoric acid (e.g. IPS ® Ceramic
Etching Gel) for 20 seconds or according to the
instructions of the manufacturer of the restorative
material.
– Thoroughly rinse with water spray and dry with oil-
free air.
1.1.3 Composite or fibre-reinforced composite restorations
–
Sandblast the restoration surface (according to the
instructions of the manufacturer of the restorative
material).
– If necessary, clean the restoration in an ultrasonic
unit for about 1 minute.
– Thoroughly rinse with water spray and dry with oil-
free air.
1.2 Apply Monobond-S with a brush or microbrush to the
pre-treated surfaces. Allow the material to react for
60 seconds. Disperse with a strong stream of air.
IMPORTANT! Contamination with saliva, blood or
water must absolutely be avoided during the entire
procedure. In case of contamination, the surfaces of
glass-ceramic, lithium disilicate glass-ceramic and
composite restorations can be cleaned with
phosphoric acid. Subsequently Monobond-S must be
applied again.
1.3 Apply the luting composite (e.g. Variolink N or Multi-
link N) according to the respective Instructions for
Use and insert the restoration.
Special notes
– If the primer dries out on the surface of the restoration
before blasting with a strong stream of air, the surface
needs to be rinsed with pure alcohol and blown with air.
– Do not insert the brush into the Monobond Plus bottle.
This may lead to contamination.
– Carefully close the Monobond-S bottle immediately after
use.
Warning
– Flammable.
– The product contains ethanol. Keep away from ignition
sources.
– Monobond-S is an irritant. Avoid contact with the skin
and mucous membrane.
If the material should accidentally come in contact with
the skin, immediately wash with copious amounts of
water.
– In rare cases, contact with the skin may lead to sensitiza-
tion towards the ingredients.
– Commercial medical gloves do not provide protection
against the sensitizing effect of methacrylates.
Storage
– Monobond-S should never be used after the expiration
date.
– Storage temperature: 2–28 °C / 36–82 °F.
– Shelf life: see expiry date on label.
Keep out of the reach of children.
For use in dentistry only.
Date information prepared
12/2009, Rev. 0
Manufacturer
Ivoclar Vivadent AG
FL-9494 Schaan / Liechtenstein
This material has been developed solely for use in dentistry. Processing should be
done strictly according to the Instructions for Use. Liability cannot be accepted for
damage resulting from failure to observe the Instructions or the stipulated area of
application. The user is responsible for testing the material for its suitability and use
for any purpose not explicitly stated in the Instructions. Descriptions and data con-
stitute no warranty of attributes and are not binding.
The Material Safety Data Sheet is available online at
www.ivoclarvivadent.com