Ivoclar Vivadent IPS Object Fix Putty-Flow - Manual

Object Fix
Putty / Flow
IP
S
®
Instructions for Use
Gebrauchsinformation
Mode d’emploi
Istruzioni d’uso
Instrucciones de uso
Instruções de Uso
607635/0408/WE1/H
For dental use only.
Caution: U.S. Federal Law restricts this
device to sale by or on the order of a
licensed dentist.
Made in Liechtenstein
Ivoclar Vivadent AG,
FL-9494 Schaan / Liechtenstein
English
Instructions for Use
Description
IPS Object Fix Putty and IPS Object Fix Flow are auxiliary firing pastes
to support all-ceramic restorations during the firing and/or
crystallization procedure. The pastes are used to stabilize and secure
the corresponding restoration on the firing tray. The pastes are
distinguished by their viscosities and can be used according to
personal preference. Given their consistency, IPS Object Fix Putty /
Flow are easy to apply, as well as easy to remove after the firing
procedure.
Indication
– Stabilization of IPS e.max
® CAD restorations during crystallization
directly on the IPS e.max CAD Crystallization Tray or on the
IPS e.max CAD Crystallization Pins.
– Securing of IPS Empress ® restorations on metal pins during the
firing procedure.
Contraindication
– IPS Object Fix Putty / Flow cannot be used for the sintering
procedure of zirconium oxide frameworks.
Composition
Oxides, water, thickening agent
General note
The failure to observe the stipulated application steps may lead to
failure.
Application
IPS e.max CAD LT, fully anatomical
1. Before crystallization, always clean the restorations with ultra-
sound in a water bath and/or steam jet. Do not blast with Al
2
O
3
or
polishing beads.
2. Select the largest possible IPS e.max CAD Crystallization Pin (S, M,
L) that best "fills" the inside of the restoration.
3. Fill the inside of crowns with IPS Object
Fix Putty / Flow up to the restoration
margin.
4. Close syringes immediately after use to
prevent the pastes from drying out.
5. Press the selected IPS e.max CAD
Crystallization Pin deeply into the
Putty / Flow material so that it is adequately secured.
6. Smooth out displaced Putty / Flow using a plastic spatula (e.g.
OptraSculpt ® ) so that the pin is securely in place and the
restoration margins optimally supported.
– Auxiliary firing paste
– Brennhilfspaste
– Pâte réfractaire support de cuisson
– Pasta di cottura ausiliaria
– Pasta auxiliar de cocción
– Pasta auxiliar de queima