Dynalink ALE800 - Manual (Page 14)

Windows Installation
The software setup process for Microsoft Windows applications (XP, 2000, Me,
98 SE, and 98) is described below with operating system specific differences
noted. The USB ADSL Modem should be connected to your PC prior to installing
the driver software. No other Windows programs should be running on your PC
during the software install process.
Note: The appearance of the windows and the wording of the options may be
slightly different for each operating system, but the same procedure
applies.
Installing the Driver Software
1. Insert the Installation CD into your CD-ROM drive. In the folder where the
driver located, double-click on setup.exe to start the DSL Modem Setup
Wizard. The Installing window displays as the Wizard prepares your system
for the installation
2. The Welcome window appears to start the next phase of the installation, and
provides an opportunity to quit the setup process to exit all Windows
programs before continuing. If the Windows programs were previously closed,
click Next.
Note: If you quit this process, run setup.exe from the Device Driver Folder to
resume the installation.