Infloor TC 204 Heating Controller - Manual (Page 12)

The menus are:
BASE 1 Set the Date, Time, Temperatures, and Timer function. Readouts
W.PR. 2 Weekly Program There are 6 time periods that can be set to begin a day, night,
or economy period. Each time can be set to begin on any day
or combination of days of the week.
D.PRO 3 Date Program There are 8 dates that can be set so that four different day, night,
or economy periods can be set to begin and end in advance.
A date setting overrides a weekly setting.
X.OUT 4 Extra Output This is an output that can be activated by temperature and/or time.
LOG 5 Log Values Running log of the outdoor temperature (or room temperature if it
is connected) for up to 96 events at intervals of up to 255 minutes.
REGUL 6 Control parameters Minimum & maximum supply temperatures, proportional bands and
integral times
RET.R 7 Return Sets the minimum return water temperature
CURVE 8 Curve selection Select the outdoor curve.
RET.R 9 Outputs Control type, outdoor cutoff temperature
INPUt 10 Inputs External contact function, internal sensor
PUMP 11 Pump Control The pump can be controlled by outdoor or supply water temperature.
CAL 12 Calibration Adjustment of the sensors to compensate for small errors in the sensor
or to compensate for the length of wire to the sensor. Adjust the clock
speed if it is running fast or slow, set the beginning and end of
daylight savings time, and set the clock for 12 or 24 hour time.
Set temperatures in Fahrenheit or Celsius.
BUT.F 13 Button Functions Security, locking, limits on settings, display
Test 14 Test Manually operate outputs, simulate temperatures, set security code
TYPE 15 TYPE This displays data about this particular controller. There are no
programmable functions.
KOMM 16 Communication ModBus
12