Pt3000_p3, Assembly instruction, Pt3000 – ikan PT3000 User Manual

Page 4: 15” teleprompter

ASSEMBLY INSTRUCTION

Attach Long L-Bracket (Part J) to the assembled parts. Make sure to arrange the long section of Part J as shown in the

illustration, otherwise there will not be adequate room to place the monitor. You will use 4 x Long Phillips head screws

(Part G) and 2 x T-plates (Part C) to attach it. Then, you will use 4 x Long Phillips head screws (Part G) and 2 x T-plates

(Part C) to attach the 10” T-slot (Part O). Make sure to evenly tighten all screws in the assembly.

PT3000

15” TELEPROMPTER

Part-O

Part-G

Part-C

Part-J

ikancorp.com

Slide the Monitor with mounting bracket onto the 10” T-slot (Part O), aligning the T-slot Nuts with the T-slots of Part O.

Refer to the diagram below.



ikancorp.com

Side View

Part-O

VGA Cable

Part-M

Part-P

Note: The VGA cable will not connect to the monitor if the monitor is slid

all the way flush to Part-M. You must connect the cable before tightening

down the monitor to insure a proper fit for the connections.

3 of 10

This manual is related to the following products: